Care & Maintenance Of Your Guitar

Thank you for purchasing a Gaskell musical instrument. We hope you will enjoy your guitar for many years to come. As with anything, there are a few basic care and maintenance procedures and key points to consider in keeping your guitar in top condition and ensuring it lasts for many years.

Body

Your guitar is made of timber. Timber expands and contracts with heat and cold and takes anywhere from two to five years to fully “settle.” Both the body itself and the fingerboard require periodic treatment in order to maintain continued excellence.

Gloss Finish

There are several readily available guitar polishes on the market.

We recommend Dunlop Formula 65 GUITAR POLISH. This is an excellent product specifically made for musical instruments and gives an excellent shine and gloss to your guitar. It does not require a lot of product to do the job so a bottle should last a long time. Please always use a clean and dry cloth and buff only lightly until done. Harsh buffing may cause scratches.

Other polishes include Errnie Ball Guitar Polish, GHS Guitar Gloss and Fender Guitar Polish.

GuitarPolishes

Matt Finish

Do not use polishes.

Use only light petroleum distillate (naphtha/white gas) products such as Shellite, VM&P NaphthaColeman Fuel, or Ronsonol to remove fingerprints or any build ups of dirt or grime. Polishes will ruin the matt finish and create a “spotty” appearance. Note: these products are highly flammable. This is noted on the bottles but we would still like to mention that you should not smoke or have candles or other flames near you when using these products.

IMPORTANT: Furniture polishes and window cleaners are not recommended for cleaning any guitar or bass. Furniture polishes contain silicone and although they can produce a deep and gorgeous lustre, they always leave a film. Window cleaner is usually 90% ammonia and 10% soap. These tend to dry out the surfaces to which they are applied. Prolonged use of furniture polish or window cleaner on guitars will ruin the guitar. We do not recommend you use any of these household products to clean and polish your Gaskell guitar.

Fingerboard

Normal use will eventually cause you fingerboard to build up with sweat and dirt from your fingers and dust and grit from the environment. An unmaintained fingerboard will eventually dry up and crack and lose its appearance and sound properties. This is true for both guitars and basses.

To remove any build up we recommend you use plain turpentine or Dunlop FINGERBOARD 01 CLEANER & PREP followed by Dunlop 02 FINGERBOARD DEEP CONDITIONER to rejuvenate your fingerboard. If your fingerboard is really bad then there is Dunlop FRETBOARD 65 ULTIMATE LEMON OIL.

No matter what, do not use products that have solvents in them. Rosewood and ebony fingerboards are oily woods. It is for this reason they are used as fretboards. Solvents will dry up the fingerboard and this is the exact opposite of what you want to happen.

Dunlop

Hardware

Tuners, knobs, jacks, controls, and frets are parts that will wear out over time as they see much use. Keep tuners and jacks clean and free of dust at least with a dry clean cloth.

There comes a time in the life of any guitar which has been played a lot when the frets will need to be replaced. Visual evidence of this will become apparent in addition to the obvious playability difficulties.

If you are concerned about your fret wear or any other hardware issues that have arisen from energetic use then perhaps consider a PLATINUM SETUP as your next set up. See section SETUPS below for details.

Electronics

Your guitar is fitted with electronic parts that as a complete system are designed to convert an audio signal into audible sound through an amplifier. There is no real maintenance involved other than to apply common sense in the treatment of the pickups on your guitar.

Obviously do not unscrew or adjust the screws on the pickups themselves. The only pickup adjustments you can make is to raise or lower their height.

Be aware that if pickups are too close to the strings they will create a “whine” which is a magnetic reaction between the strings and the poles in the pickups. Proper distance from the strings is crucial in order for the instrument to output correct sound. Setting correct pickup height is part of any standard guitar setup.

Your guitar will require a setup every 6-12 months depending on how much it is used and weather changes. Gaskell in-house setups always include checking pickup height as part of the standard process.

NOTE: If your guitar is fitted with active pickups (pickups requiring an on-board battery to run them) remember: never leave the guitar plugged in when not in use. To do so will drain the battery and your guitar will not work. To replace the battery simply requires opening the battery box (if installed) or removing the backing plate and replacing the old battery with a new one in the usual way. Any brand should suffice.

Setups

When you first purchased your Gaskell guitar your instrument was set up in our workshop here in Australia for the highest level of playability. The cost was included in the price of your guitar.

Over time the action, intonation and playability of your guitar will change. This depends on how much you play versus Time and Nature. Extreme heat or cold and sudden changes will affect your instrument. This is normal for any guitar, no matter what brand. Your guitar could require a new setup anywhere from 6-12 months after you first purchased it.

All guitars and basses require initial and subsequent setups.

A thorough guitar setup (“Platinum Setup”) involves the following: 1) checking frets, 2) checking neck angle, 3) checking nut height and cut, 4) checking bridge height, 5) checking intonation, 6) checking tuners, 7) checking all electronics, 8) checking pickup height, 9) cleaning the instrument, 10) restringing the instrument, 11) re-testing. Obviously if anything is found to be out of place or out of calibration it is fixed. The end result of any properly done setup is the instrument is again 100% playable and correct. We do all our own work, in our own workshop here in Australia. Our services include full fret replacement, reseating, levelling and recrowning, replacing or upgrading of tuners, bridges, pickups, jacks and nuts and more. If you live in Australia you can send us your guitar and we will give it the full service. Full service costs between $300-350 depending on the individual instrument. We can do this for any guitar, any brand.

General Notes

Knocks, chips, scuffs and other impact related marks or damage to your guitar are things which come with “playing guitar.” Other than those things, these simple maintenance points can be easily taken care of and will ensure a lifetime of joy with your Gaskell guitar!

© Copyright 2014. By Kevin Gaskell. Contact: onlylefthandguitars@yahoo.com.au

©2016 Gaskell Guitars Australia

Log in or Sign Up